لیویټون ۸۳۰-ټي ۳۰ Amp، ۱۲۵ ولټ، د سفر ټریلر وینیل ګراونډینګ زاویه پلګ کارونکي لارښود

پیژندنه

This manual provides comprehensive instructions for the safe and effective use of your Leviton 830-T 30 Amp, 125 Volt, Travel Trailer Vinyl Grounding Angle Plug. This commercial-grade, straight blade, angle, grounding plug is designed for reliable electrical connections in travel trailer applications. Please read all instructions carefully before installation and use.

Image: The Leviton 830-T Travel Trailer Vinyl Grounding Angle Plug, showing its compact, black vinyl construction and angled design.

د خوندیتوب مهم معلومات

خبرداری: دا محصول کولی شي تاسو ته د لیډ په شمول کیمیاوي موادو سره مخ کړي، کوم چې د کالیفورنیا ایالت ته پیژندل کیږي چې د سرطان او زیږون نیمګړتیاوې یا د زیږون نور زیان رسوي. د نورو معلوماتو لپاره، لاړ شئ www.P65Warnings.ca.gov.

• تل د بریښنایی اجزاو نصبولو یا خدمت کولو دمخه بریښنا قطع کړئ.
• ډاډ ترلاسه کړئ چې د تارونو ټولې اړیکې خوندي دي او د ځایی بریښنایی کوډونو سره مطابقت لري.
• که چیرې دا محصول زیانمن ښکاري نو مه یې کاروئ.
• This plug is designed for 30 Amp, 125 Volt applications. Do not exceed these ratings.
• Keep away from water and moisture unless specifically rated for wet conditions.

تنظیم او نصب کول

The Leviton 830-T plug requires assembly to connect to your electrical cable. Follow these steps carefully:

1. کیبل چمتو کړئ: Strip the outer jacket of your electrical cable to expose the insulated wires (typically hot, neutral, and ground). Strip approximately 3/4 inch of insulation from each individual wire.
2. پلګ جلا کړئ: Carefully open the plug housing. Note that the internal blades may be shipped loose. Identify the terminal screws for each connection.
3. د تارونو نښلول: Insert the stripped ends of the wires into the appropriate terminal openings. The deep-slotted, backed-out terminal screws are designed to securely clamp over stripped leads.
   • سره وصل کړئ ګرم wire (usually black) to the brass-colored terminal.
   • سره وصل کړئ بې طرفه wire (usually white) to the silver-colored terminal.
   • سره وصل کړئ ځمکه wire (usually green or bare copper) to the green-colored terminal.
4. خوندي اړیکې: Tighten the terminal screws firmly to ensure maximum conductivity and prevent loose connections. Verify that no stray wire strands are touching other terminals.
5. د کور بیا راټولول: Carefully position the internal components and blades, then close the plug housing. Ensure all parts fit correctly and the housing is securely fastened.

انځور: شاته view of the Leviton 830-T plug, illustrating the terminal screws for hot, neutral, and ground wire connections. Note the "MEXICO 30A - 125V" marking.

Note: Some users have reported that the blades may not be permanently installed and the wire clamps can be challenging for stranded wire. Take extra care during assembly to ensure proper and secure connections.

عملیاتي لارښوونې

Once assembled, the Leviton 830-T plug is ready for use:

1. Ensure the power source (e.g., RV park pedestal) is turned OFF before plugging in or unplugging.
2. Insert the plug firmly into a compatible 30 Amp, 125 Volt NEMA TT-30R receptacle.
3. Once fully inserted, you may turn ON the power at the source.
4. To disconnect, first turn OFF the power at the source, then firmly grasp the plug body and pull it straight out from the receptacle. Do not pull by the cord.

ساتنه

• Periodically inspect the plug for any signs of wear, cracks, or damage to the housing or blades.
• Check the cable entry point for fraying or damage.
• Ensure terminal screws remain tight. Re-tighten if necessary, with power disconnected.
• Clean the plug exterior with a dry, soft cloth. Do not use harsh chemicals or abrasive cleaners.
• کله چې کارول نه وي، پلګ په پاک او وچ چاپیریال کې وساتئ.

د ستونزو حل کول

• ځواک نشته:
  • Check if the power source (e.g., circuit breaker at the pedestal) is ON.
  • Verify that the plug is fully inserted into the receptacle.
  • کیبل او پلګ د هر ډول لیدل شوي زیان لپاره معاینه کړئ.
  • Ensure internal wiring connections are secure (refer to Setup section).
• Plug Does Not Fit into Receptacle (e.g., "mousehole"):
  • Confirm the receptacle is a NEMA TT-30R type.
  • Some RV "mouseholes" or access points may have limited space. Compare the dimensions of the plug (4.1 x 3.9 x 2.5 inches) with the available space. Minor modifications to the access point cover may be required in some cases, but always ensure safety and weather sealing.
• Difficulty Assembling Wires:
  • Ensure wires are stripped to the correct length (approx. 3/4 inch).
  • Twist stranded wires tightly before inserting them into the terminal clamps to prevent fraying.
  • Confirm the blades are correctly seated within the housing before attempting to close.

مشخصات

تضمین او ملاتړ

This Leviton 830-T plug is covered by a د 10 کال محدود تضمین. For warranty claims, technical support, or further assistance, please contact Leviton customer service. You can find contact information and additional resources on the official Leviton webسایټ: www.leviton.com.