د فانټیک FB 6 ان لاین فلټر بکس کارونکي لارښود

1. محصول ختم شوview

The Fantech FB 6 In-line Filter Box is designed to enhance indoor air quality by providing additional filtration within your HVAC ductwork. It is typically installed after an HRV (Heat Recovery Ventilator) or an inline fan to filter incoming air. This unit includes a MERV 13 filter for efficient particle removal.

شکل ۱: بهرنۍ برخه view of the Fantech FB 6 In-line Filter Box, showing the duct connection on the left and the access knob on the right.

2. د خوندیتوب معلومات

Please read all instructions carefully before installation and operation. Failure to follow these instructions may result in property damage, injury, or death.

• Ensure power to the HVAC system is disconnected before installation or maintenance.
• د نصب او ساتنې پرمهال مناسب شخصي محافظتي تجهیزات (PPE) واغوندئ.
• Consult a qualified HVAC professional for complex installations or if you are unsure about any steps.
• که چیرې کومې برخې زیانمنې یا ورکې وي، نو یونټ مه چلوئ.
• Dispose of old filters according to local regulations.

3. د بسته محتويات

د نصبولو پیل کولو دمخه ډاډ ترلاسه کړئ چې ټولې برخې شتون لري.

• Fantech FB 6 In-line Filter Box
• MERV 13 Filter (pre-installed or separate)
• د نصبولو لارښود (دا لارښود)

4. نصب او تنظیم کول

4.1 د نصب څخه دمخه چیک لیست

• Confirm duct size compatibility (6-inch duct).
• Ensure adequate space for installation and future filter replacement.
• Gather necessary tools (e.g., duct cutters, sealant, screwdriver).

4.2 د نصبولو مرحلې

1. ځای وټاکئ: Install the filter box in the ductwork after your HRV or inline fan, ensuring it is accessible for maintenance.
2. د ډیکټ ورک چمتو کول: Cut a section of the existing 6-inch ductwork to accommodate the filter box. Ensure clean, straight cuts.
3. Connect to Ductwork: Slide the filter box onto the prepared duct ends. Secure connections using appropriate duct clamps or screws and seal with HVAC-approved tape or mastic to prevent air leaks.
4. Verify Filter Installation: Open the access panel (refer to Figure 2) and ensure the MERV 13 filter is correctly seated.
5. د خوندي لاسرسي پینل: Close and secure the access panel using the provided knobs/screws.

شکل 2: داخلي view of the Fantech FB 6 In-line Filter Box with the access panel open, revealing the MERV 13 filter angled inside.

5. عملیات

The Fantech FB 6 In-line Filter Box operates passively as part of your ventilation system. Once installed, it continuously filters the air passing through it. No user interaction is required for its daily operation.

6. ساتنه

6.1 د فلټر ځای په ځای کول

Regular filter replacement is crucial for maintaining optimal air quality and system performance. The frequency of replacement depends on usage and environmental conditions, but it is generally recommended every 3-6 months.

1. د بریښنا قطع کول: Ensure the HVAC system connected to the filter box is powered off at the circuit breaker.
2. د لاسرسي پینل پرانیزئ: Loosen the knobs/screws on the access panel and carefully open it.
3. زوړ فلټر لرې کړئ: Gently slide out the old MERV 13 filter. Note its orientation for correct installation of the new filter.
4. نوی فلټر داخل کړئ: Slide a new MERV 13 filter into the filter box, ensuring it is properly seated and oriented.
5. د لاسرسي پینل بند کړئ: Close the access panel and tighten the knobs/screws securely.
6. د بریښنا بیرته راګرځول: Turn the power back on to the HVAC system.

7. ستونزه حل کول

8. مشخصات

9. تضمین او ملاتړ

For warranty information and technical support, please refer to the official Fantech webسایټ یا د دوی پیرودونکي خدمت سره اړیکه ونیسئ.

You can visit the official Fantech store on Amazon for more products and information: FANTECH Store.