1. پهview
The PAC LP7-2 L.O.C. PRO Series 2-Channel Line Output Converter is designed to integrate aftermarket amplifiers with factory (OEM) car audio systems. It optimizes audio levels between the radio and amplifier to achieve the best audio performance and minimize noise. This unit features a full 20-20k +/-1.5dB frequency response, unique stereo gain controls, and a universal harness for versatile installation.
کلیدي ځانګړتیاوې:
- PRO Series 2-Channel High Power Line Output Converter
- Optimizes audio levels between radio and amplifier for superior sound quality
- Ideal for adding an amplifier to an OEM system
- Configurable for speaker level or RCA level input/output
- Single dial, precision-matched stereo gain adjustment
- Signal-sensing circuit for amplifier remote turn-on
2. د خوندیتوب معلومات
خبرداری: دا محصول هغه کیمیاوي مواد لري چې د کالیفورنیا ایالت ته پیژندل شوي چې د سرطان او زیږون نیمګړتیاوې یا د زیږون نور زیانونه رامینځته کوي. د نورو معلوماتو لپاره، مهرباني وکړئ لیدنه وکړئ www.p65warnings.ca.gov.
Always ensure proper electrical connections and insulation to prevent short circuits or damage to vehicle electronics. Disconnect the vehicle's battery before installation. Consult a professional if you are unsure about any installation steps.
۲. په بکس کې څه دي؟
د بسته بندۍ پرانستلو سره، ډاډ ترلاسه کړئ چې ټولې برخې شتون لري:
- PAC LP7-2 Line Output Converter unit
- د بریښنا مزي
- د لارښود لارښود (دا سند)
4. ترتیب او نصب کول
Careful installation is crucial for optimal performance. Follow these steps for proper setup:
4.1. د تارونو نښلول
The LP7-2 connects to your factory speaker wires and provides RCA outputs for your amplifier, along with a remote turn-on lead.
- د ننوتلو تارونه: Connect the high-level input wires from your factory radio's speaker outputs to the corresponding inputs on the LP7-2 harness. Ensure correct polarity (positive to positive, negative to negative).
- ځمکه: Connect the chassis ground wire (black) to a solid metal point on the vehicle's chassis. An optional audio ground output (brown) is available.
- 12V Constant: Connect the 12V constant wire (yellow) to a constant 12V power source.
- ریموټ چالان: The LP7-2 features a signal-sensing remote turn-on. The blue wire provides a 12V remote output (500mA max) to turn on your amplifier when an audio signal is detected.
- د RCA پایلې: Connect the RCA cables from the LP7-2's output jacks to the input jacks on your aftermarket ampلايف
4.2. د سمون ترلاسه کول
The LP7-2 features a single dial for precision-matched stereo gain adjustment. This control allows you to match the output level of the converter to the input sensitivity of your ampلايف
- Start with the gain control on the LP7-2 set to its minimum position.
- خپل وګرځوئ amplifier's gain control to its minimum setting.
- Play a dynamic piece of music through your system at a moderate volume level.
- Slowly increase the gain on the LP7-2 until the desired output level is achieved without distortion.
- ښه ټون د amplifier's gain control if necessary, ensuring no audible distortion at high volumes.
5. عملیات
Once properly installed and configured, the PAC LP7-2 operates automatically. When your factory radio is turned on and produces an audio signal, the LP7-2 will detect this signal and activate its remote turn-on output, signaling your amplifier to power on. When the audio signal ceases (e.g., when the radio is turned off), the LP7-2 will deactivate the remote turn-on, causing the amplifier to power off.
The gain adjustment, as described in Section 4.2, is a one-time setup process to ensure optimal audio level matching between your factory radio and aftermarket ampلايف
6. ساتنه
The PAC LP7-2 is designed for reliable, maintenance-free operation. To ensure longevity and consistent performance:
- Ensure the unit is installed in a dry location, away from excessive heat, moisture, and direct sunlight.
- Periodically check all wiring connections for tightness and corrosion. Loose connections can lead to signal degradation or intermittent operation.
- Keep the unit free from dust and debris. A soft, dry cloth can be used for cleaning the exterior.
7. ستونزه حل کول
If you encounter issues with your PAC LP7-2, refer to the following common problems and solutions:
| ستونزه | احتمالي لامل | د حل لاره |
|---|---|---|
| څخه هیڅ غږ نشته ampلایفیر/سوب ووفر |
|
|
| تحریف یا ضعیف غږ کیفیت |
|
|
| Amplifier does not turn on/off with radio |
|
|
| د هسک یا ګونګ غږ |
|
|
8. مشخصات
| فیچر | مشخصات |
|---|---|
| ماډل | LP7-2 |
| برانډ | PAC |
| د چینلونو شمیر | 2 |
| د انٹرفیس ډول | RCA |
| د نصب کولو ډول | د سطحې غر |
| د محصول ابعاد (L x W x H) | ۶.۳" x ۱.۵" x ۳.۶" (تقریبا) |
| د توکي وزن | ۱۵.۰۴ اونس (تقریبا) |
| د ریموټ ټرن-آن محصول | 12V (500mA max) |
| د تعدد ځواب | 20-20k +/-1.5dB |
9. د تضمین معلومات
For detailed warranty information regarding the PAC LP7-2, please refer to the official warranty document provided with your product or visit the manufacturer's webسایټ. د تضمین شرایط او مقررات ممکن توپیر ولري.
10. د ملاتړ او اړیکو معلومات
If you require further assistance or have questions not covered in this manual, please contact PAC customer support:
- جوړونکی: AAMP of America (PAC)
- پته: Pacific Accessory Corporation®, Santa Ana, California 92705
- تلیفون: 866-931-8021
- بریښنالیک: support@pac-audio.com
- Webسایټ: www.pac-audio.com
