ZTW TY15124544

ZTW Mantis Slim 15A Brushless ESC Instruction Manual

موډل: TY15124544

1. پیژندنه

The ZTW Mantis Slim 15A Brushless Electronic Speed Controller (ESC) is designed for F3P airplanes and gliders, offering super smooth startup and throttle response. This manual provides essential information for safe and efficient operation of your ESC. Please read it thoroughly before use.

2. کلیدي ځانګړتیاوې

3. مشخصات

فیچرارزښت
ESC Size (LxWxH)27mm x 14mm x 5.5mm
د ننوتلو ځواک2-4S Lipo / 5-12NC
د BEC محصول2A/5V (3A peak)
دوامداره جریان15A
وزن6.8 ګرامه
د موټرو نښلونکی2.0mm female bullet connector
د بریښنا نښلونکیJST (female case with male pin)

Product Dimensions: 1.2 x 1 x 0.1 inches. Item Weight: 0.64 ounces.

ZTW Mantis Slim 15A ESC with detailed dimensions

Figure 1: ZTW Mantis Slim 15A ESC with detailed dimensions (Length: 27mm, Width: 14mm, Height: 5.5mm).

۱. تنظیم او نصب کول

Proper installation is crucial for the performance and safety of your ESC. Follow these steps carefully:

4.1 د تارونو نښلول

ZTW Mantis Slim 15A ESC with labeled 2.0mm female bullet motor connectors and JST female power connector

Figure 2: ZTW Mantis Slim 15A ESC showing 2.0mm female bullet motor connectors and JST female power connector.

4.2 د ESC نصب کول

Choose a location that has good airflow to offer best cooling to prevent overheating. Do NOT cover the side with the flat heat shield with hook and loop tape or any other material as this will greatly lower its effectiveness. Mount the ESC with a combination of hook and loop tape or 2-sided foam tape.

Video 1: Brushless ESC for Drone & RC Plane Easy to install (Source: HAWK'S WORK). This video demonstrates the general installation process of a Brushless ESC for a Drone or RC Plane, highlighting easy installation steps.

5. عملیاتي لارښوونې

Always perform throttle calibration before the first use or if you change your transmitter.

5.1 د Throttle کیلیبریشن

  1. خپله راډیو چالان کړئ او د تختې چپکۍ په پورتنۍ حالت کې وساتئ.
  2. Connect the battery pack to the ESC. Wait for about 2 seconds, the motor will beep twice, then pull the throttle to the minimum position. The motor will also beep, which indicates that your ESC has got the signal range of the throttle from your transmitter.

Video 2: How to do throttle calibration for Mantis Slim G2 20A/30A (Source: ZTW Model). This video provides instructions on how to perform throttle calibration for the Mantis Slim G2 20A/30A ESC, which is applicable to the 15A model.

Video 3: How to calibrate ESC (Source: HAWK'S WORK). This video demonstrates the general process of calibrating an ESC, which can be helpful for understanding the throttle calibration process.

۴.۳ د ESC پروګرام کول

The ZTW Mantis Slim ESC can be programmed using a ZTW Beatles series programming card or directly via your transmitter.

5.2.1 Using an LCD Program Card

  1. Unplug the ESC throttle cable from the receiver.
  2. Insert the LCD Program Card G2 into the ESC's throttle cable port.
  3. ESC له بیټرۍ سره وصل کړئ.
  4. Wait for the LCD screen to display the power-on interface.
  5. Press the "ITEM" or "OK" button to enter the parameter setting interface.
  6. Use the navigation buttons to select parameters and adjust values.
  7. Upon completion of programming, press the "OK" button to save the parameters.

Video 4: How to set parameter for Mantis Slim G2 20A/30A by LCD Card (Source: ZTW Model). This video demonstrates how to set parameters for Mantis Slim G2 20A/30A using an LCD Card, which is applicable to the 15A model.

5.2.2 Setting SMR (Switch Motor Rotation) Function

The SMR function allows you to change the motor rotation direction. It is only allowed to be used when the aircraft is landing on the ground, and it can effectively shorten the landing distance of the aircraft.

Video 5: Set the SMR (Reverse) function of your ESC (Source: TOYTENSI). This video explains how to set the SMR (Switch Motor Rotation) function for your ESC, which is useful for controlling motor direction during landing.

6. ساتنه

To ensure the longevity and optimal performance of your ZTW Mantis Slim ESC, follow these maintenance guidelines:

7. ستونزه حل کول

که تاسو د خپل ESC سره ستونزې سره مخ شئ، نو لاندې عام ستونزې حل کولو ګامونه په پام کې ونیسئ:

8. د خوندیتوب معلومات

Always prioritize safety when operating RC equipment. Failure to do so may result in property damage, injury, or death.

9. تضمین او ملاتړ

ZTW and HAWK HOBBY offer a 100% free warranty for this ESC. For any issues or support needs, please contact your retailer or the manufacturer directly.

اړوند اسناد - TY15124544

مخکېview د ZTW مانټیس سلیم G2 15A ESC کارونکي لارښود
د ZTW Mantis Slim G2 15A ESC لپاره د کارونکي لارښود، د RC الوتکو لپاره د ځانګړتیاوو، مشخصاتو، تنظیم، پروګرام کولو، او ستونزو حل کولو توضیحات. د غوره فعالیت لپاره د خپل ESC کیلیبریټ، پروګرام کولو او ساتلو څرنګوالی زده کړئ.
مخکېview د ZTW مانټیس سلیم G2 لړۍ ESC کارونکي لارښود
د ZTW مانټیس سلیم G2 لړۍ برشلیس الیکترونیکي سرعت کنټرولر (ESC) لپاره د کارونکي لارښود، د RC غوښتنلیکونو لپاره د ځانګړتیاوو، مشخصاتو، تنظیم، پروګرام کولو، او ستونزو حل کولو توضیحات.
مخکېview د ZTW SkyHawk لړۍ ESC کارن لارښود
د ZTW SkyHawk لړۍ د برش پرته بریښنایی سرعت کنټرولرونو (ESCs) لپاره د کارونکي لارښود، د RC الوتکو او چورلکو لپاره د ځانګړتیاوو، مشخصاتو، او ستونزو حل کولو توضیحات.
مخکېview د ZTW بیسټ پرو 30A G2 BLE برش پرته ESC کارونکي لارښود
د ZTW Beast Pro 30A G2 BLE ESC لپاره د کارونکي لارښود، چې د 1:28 RC موټرو لپاره ځانګړتیاوې، مشخصات، کیلیبریشن، د اپلیکیشن کارول، او د پروګرام وړ ترتیبات پوښي.
مخکېview د ZTW برش پرته ESC پروګرام کارت لارښوونې
د ZTW د برشلیس ESC پروګرام کارت کارولو لپاره لارښوونې ترڅو د ZTW د برشلیس بریښنایی سرعت کنټرولر پیرامیټرونه تنظیم کړي. د ESCs سره د جوړ شوي BEC سره او پرته کارول پوښي.
مخکېview ZTW Beast Pro 120A, 160A, 220A Brushless ESC User Manual
User manual for ZTW Beast Pro series brushless electronic speed controllers (ESC) models 120A, 160A, and 220A. This guide details features, specifications, setup, calibration, and advanced programming options for 1:10 & 1:12 scale RC cars and trucks, enhancing performance and driveability.