Maxxima LED Slide Dimmer Switch User Manual

1. پیژندنه

Thank you for choosing the Maxxima LED Slide Dimmer Switch. This product is designed to provide smooth and reliable dimming for a variety of lighting loads, including incandescent, dimmable LED, and CFL bulbs. It supports both single pole and 3-way circuit configurations, offering flexibility for your lighting control needs. Please read this manual thoroughly before installation and use to ensure proper operation and safety.

2. د خوندیتوب معلومات

خبرداری: د اور، شاک یا مرګ څخه د مخنیوي لپاره؛ په سرکټ بریکر یا فیوز کې بریښنا بنده کړئ او د تار لګولو دمخه ازموینه وکړئ چې بریښنا بنده ده! دا وسیله باید د ټولو ملي او محلي بریښنا کوډونو سره سم نصب شي.

• یوازې د داخلي کارونې لپاره.
• Do not use with non-dimmable lighting fixtures.
• Not for use with ceiling fans or motor loads.
• ټول واټ ډاډمن کړئtage of connected bulbs does not exceed the dimmer's maximum rating (600W Incandescent; 200W Dimmable LED/CFL).
• که تاسو د دې لارښوونو د کومې برخې په اړه ډاډه نه یاست ، د بریښنایی تکنالوژی څخه مشوره وکړئ.

3. د بسته محتويات

• Maxxima LED Slide Dimmer Switch (Model: MEW-DM650)
• بې رنګه دیوال پلیټ
• د سکرو نصب کول
• د سیم مغزونه

4. ترتیب او نصب کول

This dimmer switch is compatible with both single pole and 3-way wiring configurations. In a 3-way circuit, only one dimmer may be used; the second switch must be an ON/OFF only switch.

4.1 د تارونو ډیاګرام

Refer to the following image for typical wiring connections. Always ensure power is OFF before beginning any wiring.

4.2 د نصبولو مرحلې

1. بریښنا بند کړئ: At the circuit breaker or fuse box, turn off the power to the switch location. Verify power is off using a voltage ټیسټر.
2. زوړ سویچ لرې کړئ: په احتیاط سره د دیوال موجوده پلیټ او سویچ د دیوال بکس څخه لرې کړئ. تارونه د زاړه سویچ څخه جلا کړئ.
3. د تارونو پیژندنه: Identify the LINE (hot), LOAD, and GROUND wires. For 3-way installations, also identify the TRAVELER wires.
4. د تارونو نښلول: Connect the wires from the wall box to the dimmer switch using the provided wire nuts.
   • Black wire on dimmer: Connect to LINE (hot) wire.
   • Red wire(s) on dimmer: Connect to LOAD wire (and TRAVELER wire for 3-way).
   • Green wire on dimmer: Connect to GROUND wire.
5. ماونټ ډیمر: Carefully push the wired dimmer switch into the wall box. Secure it with the provided mounting screws.
6. د دیوال پلیټ ضمیمه کړئ: Snap the screwless wall plate onto the dimmer switch.
7. د بریښنا بیرته راګرځول: په سرکټ بریکر کې بریښنا بیرته فعاله کړئ.

4.3 Sensitivity Adjustment (Trim Dial)

The dimmer features a trim dial located underneath the cover plate. This dial allows you to adjust the low-end dimming range to ensure optimal compatibility with various LED and CFL lamps, preventing flicker or premature turn-off at low light levels.

To adjust: Remove the screwless wall plate. Locate the small trim dial at the bottom of the dimmer. Turn the dial clockwise to increase the minimum light level or counter-clockwise to decrease it, until stable dimming is achieved without flicker.

5. عملیاتي لارښوونې

The Maxxima LED Slide Dimmer Switch features a vertical slide control for dimming and a separate ON/OFF button.

• آن/بندول: Press the bottom button to turn the lights ON or OFF.
• دیمینګ: Move the vertical slide control up to increase light brightness and down to decrease light brightness.

6. ساتنه

The Maxxima LED Slide Dimmer Switch requires minimal maintenance. To clean, simply wipe the surface with a soft, damp ټوکر. د کثافاتو پاکوونکي یا محلولونه مه کاروئ، ځکه چې دا ممکن پای ته زیان ورسوي.

7. ستونزه حل کول

• څراغونه په سمه توګه نه ځلیږي یا نه کمیږي: Adjust the sensitivity trim dial (refer to Section 4.3). Ensure your bulbs are dimmable LED or CFL, or incandescent.
• څراغونه نه خلاصیږي: Check the circuit breaker. Verify all wiring connections are secure. Ensure the dimmer is not connected to a non-dimmable fixture.
• Dimmer does not work with low wattage LED loads: The dimmer may not be compatible with LED loads of 4.5 watts or less. Consider increasing the total wattage of connected LED bulbs.
• Dimmer gets warm: It is normal for dimmers to feel warm during operation. If it becomes excessively hot or emits a burning smell, immediately turn off power at the circuit breaker and consult a qualified electrician.
• Not for use with ceiling fans: This dimmer is designed for lighting loads only and should not be used to control ceiling fans or other motor-driven appliances.

8. مشخصات

9. تضمین او ملاتړ

The Maxxima LED Slide Dimmer Switch comes with a 1 کلن تضمین from the date of purchase, ensuring safety and reliability. This warranty covers defects in materials and workmanship under normal use.

For technical support, troubleshooting assistance, or warranty claims, please contact Maxxima customer service. Refer to the product packaging or the Maxxima webد اړیکو د تازه معلوماتو لپاره سایټ.