1. پیژندنه
This manual provides comprehensive instructions for the VINABTY RAV510 ZK06600 replacement remote control. This remote is designed to be compatible with various Yamaha AV Receiver models, offering a direct replacement without the need for complex programming. Please refer to the sections below for setup, operation, troubleshooting, and product specifications.
2. محصول ختم شوview
The VINABTY RAV510 ZK06600 remote control is a dedicated replacement unit for specific Yamaha AV Receiver models. It features a standard button layout for intuitive control of your audio-visual system.
کلیدي ځانګړتیاوې:
- No programming required; ready to use after battery installation.
- Compatible with Yamaha AV Receiver models: RX-V677, RX-A740, RX-A740BL, XV-5047, TSR-7850, TSR-7810, RAV475 ZK066000.
- د دوامدار ABS موادو څخه جوړ شوی.
- Designed for stable signal transmission and quick response time.
This image displays the front of the VINABTY RAV510 ZK06600 remote control, showing the layout of all control buttons, including power, input selectors, volume, navigation, and numeric keypad.
3. ترتیب کول
د بیټرۍ نصب کول:
- د ریموټ کنټرول شاته د بیټرۍ کڅوړه ومومئ.
- د بیټرۍ د برخې پوښ ښکته خوا ته وغورځوئ او لرې یې کړئ.
- Insert two new AAA alkaline batteries (1.5V) into the compartment. Ensure the positive (+) and negative (-) ends are aligned correctly according to the markings inside the compartment. Do not use AA batteries or rechargeable batteries.
- د بیټرۍ د برخې پوښ بیرته خپل ځای ته د سلایډ کولو سره بدل کړئ تر هغه چې په خوندي ډول کلیک وکړي.
یادونه: This remote control does not require any programming. It is designed to work directly with the specified Yamaha AV Receiver models once batteries are installed correctly.
This image illustrates the open battery compartment, indicating the correct positive (+) and negative (-) polarity for inserting two AAA batteries.
The back of the remote control is shown, highlighting the battery compartment cover located at the bottom.
4. عملیاتي لارښوونې
To operate your Yamaha AV Receiver with the VINABTY RAV510 ZK06600 remote control, ensure there are no obstructions between the remote and the receiver's infrared (IR) sensor. Point the remote control directly towards the IR sensor on your AV receiver.
اساسي دندې:
- ځواک: فشار ورکړئ ځواک button to turn the receiver on or off.
- د ننوتلو انتخاب: د کارولو HDMI, AV, تونر, USB, NET buttons to select your desired input source.
- د حجم کنټرول: د کارولو حجم + او حجم - buttons to adjust the audio level. Press خاموش to temporarily silence the audio.
- نیویگیشن: د تیر تڼۍ وکاروئ (Up, ښکته, کیڼ, سمه ده) او ننوتل د مینو نیویګیشن لپاره تڼۍ.
- عددي کیپډ: Use the number buttons (0-9) for direct input or channel selection.
5. ستونزه حل کول
If the remote control is not functioning as expected, please follow these troubleshooting steps:
عام مسایل او حل لارې:
- No Response or Remote Does Not Work:
- د بیټرۍ معاینه: Install two new AAA alkaline batteries. Ensure they are correctly installed with the positive (+) and negative (-) ends in the right direction (+ to -; - to + polarity). Incorrect installation will prevent the remote from working.
- مطابقت: Verify that your AV receiver model number is listed as compatible with this remote control.
- خنډ: Ensure there are no physical blocks between the remote control and the AV receiver's IR sensor. The effective control range is approximately 10 meters (33 feet) within a 30-degree angle.
- Remote Still Not Working After Initial Checks:
- Drain Residual Power: Remove the batteries from the remote. Press every button on the remote for at least 3-5 seconds to drain any residual power. This also helps to check for stuck buttons.
- Clean IR Sensor: Check if the IR sensor area of your AV receiver is clean. Dust or debris can sometimes affect the IR sensor connection.
- د لید روښانه کرښه: Confirm that nothing is blocking the front of your AV receiver and that there are no barriers between the remote and the receiver. Always point the remote control directly towards the remote control sensor on the AV receiver.
- Restart Receiver: Unplug the power supply of your AV receiver from the wall outlet, wait for a few seconds, and then plug it back in to restart it. After the receiver has fully powered on, try using the remote again.
6. مشخصات
| مشخصات | ارزښت |
|---|---|
| د ماډل شمیره | RAV510 ZK06600 |
| د محصول ابعاد | 5 x 1.9 x 0.5 انچه (12.7 x 4.8 x 1.3 سانتي متره) |
| د توکي وزن | 2.9 اونس (82 ګرامه) |
| د بیټرۍ ډول | ۲ x AAA الکلین بیټرۍ (شامل نه دي) |
| رنګ | تور |
| مطابقت لرونکې وسیلې | Yamaha AV Receivers (specific models listed in Introduction) |
| جوړونکی | XINHAO |
A diagram illustrating the physical dimensions of the remote control, measuring approximately 21.2 cm (8.35 inches) in length and 5 cm (1.97 inches) in width.
7. ساتنه
د خپل ریموټ کنټرول د اوږد عمر او سم فعالیت ډاډمن کولو لپاره، د ساتنې دا لارښوونې تعقیب کړئ:
- پاکول: ریموټ کنټرول په منظم ډول د نرم، وچ ټوکر سره پاک کړئ. د سختې خاورې لپاره، یو څه کم کړئampټوکر د اوبو یا یو نرم، غیر خارښونکي پاکونکي سره ومینځئ. د سخت کیمیاوي موادو یا محلولونو کارولو څخه ډډه وکړئ.
- د بیټرۍ بدلول: Replace batteries promptly when the remote's performance diminishes. Always replace both batteries at the same time with new AAA alkaline batteries.
- ذخیره کول: که چیرې ریموټ کنټرول د اوږدې مودې لپاره ونه کارول شي، نو بیټرۍ لرې کړئ ترڅو د لیکیدو او وسیلې ته د احتمالي زیان مخه ونیول شي.
- د زیانونو مخنیوی: Do not expose the remote to extreme temperatures, direct sunlight, moisture, or impact.
8. تضمین او ملاتړ
For warranty information or technical support regarding your VINABTY RAV510 ZK06600 remote control, please refer to the seller or retailer from whom you purchased the product. They can provide specific details regarding return policies, warranty coverage, and assistance with any product-related inquiries.
