د سیسکو PIM سیلولر پلګ ایبل انٹرفیس ماډل کارن لارښود

د سیسکو PIM سیلولر پلګ ایبل انٹرفیس ماډل

مشخصات

• د سیم لاک او انلاک وړتیاو ملاتړ کوي
• د بیک اپ موخو لپاره د دوه سیم کارتونو ملاتړ
• د مناسب فرم ویئر لپاره د اتوماتیک سیم فعالول
• د عامه ځمکې ګرځنده شبکې (PLMN) انتخاب
• د خصوصي LTE او خصوصي 5G شبکې ملاتړ
• دوه فعال PDN پروfileد سیلولر انٹرفیس کې
• د IPv6 ډیټا ټرافیک لپاره ملاتړ
• په سیسکو IOS-XE کې د سیلولر خدماتو وړتیا ځانګړتیاوې

د سیلولر PIM تنظیم کولو لپاره شرطونه

نوټ

You must have the appropriate antennas and antenna accessories to complete your installation. Consult the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for suggestions on possible solutions.

• If the signal is not good at the router, place the antenna away from router in a better coverage area. Please refer to the RSSI/SNR values as displayed through show cellular <x/x/x> all or the LED of the pluggable modem.
• You must have cellular network coverage where your router is physically placed. For a complete list of supported carriers.
• You must subscribe to a service plan with a wireless service provider and obtain a Subscriber Identity Module (SIM) card. Only micro SIMs are supported.
• You must install the SIM card before configuring the Cellular PIM or router.
• The standalone antenna that supports GPS capabilities must be installed for the GPS feature to work when available on the PIM.

د سیلولر PIM تنظیم کولو لپاره محدودیتونه

• Currently, cellular networks support only user initiated bearer establishment.
• Due to the shared nature of wireless communications, the experienced throughput varies depending on the radio network capabilities, number of active users or congestion in a given network.
• Cellular bandwidth is asymmetric with the downlink data rate being greater than the uplink data rate, while on private cellular with TDD frequency band(s), it may be symmetrical.
• Cellular networks have higher latency compared to wired networks. Radio latency rates depend on the technology and carrier. Latency also depends on the signal conditions and can be higher because ofnetwork congestion.
• CDMA-EVDO, CDMA-1xRTT, and GPRS technology modes are not supported. 2G is only supported on the P-LTE-GB.
• Any restrictions that are part of the terms of service from your carrier.
• SMS—Only one text message up to 160 characters to one recipient at a time is supported. Larger texts are automatically truncated to the proper size before being sent.

ځانګړتیاوې نه ملاتړ کیږي

The following features are not supported:

• On Cisco IOS-XE, TTY support or Line is not available on cellular interface as it was on IOS classic.
• On Cisco IOS-XE, explicit Chat script /Dialer string doesn’t need to be configured for the cellular interface as it was on IOS classic.
• DM log output to USB flash is not supported
• غږیز خدمتونه

د سیلولر PIM مهمې ځانګړتیاوې

The PIM supports the following major features:

FAQ

• پوښتنه: ایا زه کولی شم د سیسکو سیلولر پلګیبل انٹرفیس ماډل سره هر ډول انتن وکاروم؟
  • A: No, it is recommended to use antennas and accessories specified in the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for compatibility and performance.
• پوښتنه: د PDN څو پرو؟fileایا s په سیلولر انٹرفیس کې فعال کیدی شي؟
  • الف: تر دوو پورې PDN پروfiles can be active on the Cellular interface, depending on the SIM subscription and services.